Smart Life Thermostat Leak Water Meter Monitor Valve Boiler Controller Detector Tuya WIFI Tank Water Level Temperature Sensor
Product selling point:
1. Using high-quality materials, the quality is guaranteed
2. Real-time synchronous feedback of remote output status and water level
3. It can run independently without WIFI, and realize the function of single-machine control of water level
4. The on-off of one output can be controlled remotely or manually on site (when the set water level value is not
reached)
5. It can control drainage with high opening and low closing, or control water replenishment with low opening and
high closing, or select time-limited control mode
6. Remote upper and lower water level alarm APP push function
7. APP can display the current water level, start water level, stop water level, upper and lower limit alarm water level
8. Two outputs, one water level control, one anti-dry function
9. The main account can share the device with others, and the device can only be added under one main account (note that the alarm can only be realized if the device and the mobile phone are both online. Without the network, it is like the mobile phone can’t make a call without a signal!)
Parameter:
Model: YF-S201
Interface size: 4 points (G1/2)
Operating voltage range: DC5 ~ 15V
Inner/Outer Diameter: 10.9mm/20mm
Thread length: 14.5mm12.5mm
Material: Nylon
Water pressure resistance: ≤1.75MPa
Output pulse high level: >DC4.7V (input voltage DC5V)
Output pulse low level: <DC0.5V (input voltage DC5V)
Insulation resistance: >100MQ
Flow range: 1～30LMIN
Airtightness: Close each hole, add 1.7Mpa water pressure test for 1 minute without leakage and deformation
Flow pulse characteristics: F= (7.5*Q) error≤3%
Configuration process:
Installation preparation:
Search for “”Tuya Smart”” on the phone and install the APP.
After installing the APP, please use your mobile phone or email to register an account.
Note that if you are using a for Android phone, please use the system default font, otherwise it will display confusion
Mobile APP adding device process:
1. Connect the wires according to the wiring diagram. After the first power-on, wait for a few seconds, the indicator light 1 flashes quickly, and the device enters the WIFI configuration mode by default.
Note: If the device has been added to the APP and needs to be reconfigured, press and hold the configuration button in the working state until the indicator lights 1 and 2 flash at the same time, and then release the button. At this time, the device enters the smart configuration mode. The router is not compatible, at this time, you can press and hold the configuration button again, the indicator lights 1 and 2 flash slowly, and then enter the compatibility mode configuration.
2. Open the APP, and click the “+” icon in the upper right corner to select any device.
3. Click “Confirm the indicator light is flashing quickly” on the APP
4. Prompt to select a wifi that can access the Internet normally and enter the password. After confirming the password and entering it correctly, click “OK”.
4.1 The device uses 2.4G wifi communication protocol, and does not support 5G network for the time being.
4.2 If the network is set to hide or filter the MAC address, please ask the network administrator to enter the background to modify the settings,
and then add the device.
5. The APP automatically starts to configure, and the device is added successfully when the progress bar is reached.
6. After adding successfully, you can rename the device.
Note: After the addition is successful, the device will be automatically deleted from the current APP if it is reconfigured.
Parameter:
Appearance size: 89*55*44mm
Installation method and size: standard 35MM rail installation
Working power and power consumption: AC220V; <2W
Water level display: five-level water level display: 0%, 25%, 50%, 75%, 100%
Water level control range: full water level: 25%, 50%, 75%, 100% make-up water level: 25%, 50%, 75%, 100%
Time limit range: 0-720 minutes, need to be set on the APP, step by 5 minutes to set
Relay life: on and off 100,000 times
Operating environment: -10℃~50℃
Wireless standard: WIFI2.4GHZ B/G/N
Parameter memory: long-term memory of setting parameters when power off, can run offline
Package list:
Water level controller*1
Water level electrode*5
4 GREAT REASONS TO BUY FROM US:
- Over 37,000 happy customers worldwide
- Real people on our support team ready to help
- The finest materials and stunning design — all our products are developed with an obsessive dedication to quality, durability, and functionality
- We use the most secure online ordering systems on the market, and are constantly improving our software to make sure we offer the highest possible security
BUY WITH CONFIDENCE
Our mission is to make your shopping experience as safe and enjoyable as possible. Have questions? Feel free to contact our award-winning customer care team for advice on everything from product specifications to order tracking.
- Money back guarantee: Something not quite right? If you’re not totally satisfied with your purchase, you can return it within 15 days for a full refund
- Risk-Free Purchase: We utilize industry-standard Secure Sockets Layer (SSL) technology to allow for the encryption of all the sensitive information, so you can be sure your details are completely safe with us
- Trustworthy payment method: We partner with the most popular online payment solutions that guarantee enhanced security and fast transaction processing
